My score today December 27, 2009, 03:55:10 AM Well today (saturday) I picked up front and rear swaybars, rack and pinion and hood from 88 turbocoupe for 100 bucks. I do need to do some work on the hood. it has some rust along the front 2 inches or so that ill need to sand down and repair but it shouldnt be all that bad. now to make it fit my car with a 5.0 efi lol Quote Selected
My score today Reply #1 – December 27, 2009, 03:21:04 PM To make it fit you should just have to grind the alt. bracket down alittle bit.. I had to and the hood closes fine now. Quote Selected
My score today Reply #2 – December 27, 2009, 04:34:18 PM My alternator bracket is fine.The a/c bracket had to be helped a little. Quote Selected
My score today Reply #3 – December 27, 2009, 05:49:31 PM good ill know what to check for lol Quote Selected
My score today Reply #4 – December 27, 2009, 06:12:18 PM lol just dont slam the hood shut the first time or you might have a dimple or two to fix Quote Selected
My score today Reply #5 – December 27, 2009, 09:14:11 PM We put a 5.0 with a Vortech on it into my son's project TC and we didn't have to modify it at all. The hood fit just fine. Oh, I take that back, we did remove the plastic duct work. That was it though.Having said that, follow T-BirdX3's advice anyway. Close it very carefully the first few times, just to be safe. Quote Selected
My score today Reply #6 – December 27, 2009, 10:02:37 PM Where were the parts from? Any cheap set of snowflake rims or radio/center bezel? Quote Selected
My score today Reply #7 – December 28, 2009, 12:17:10 AM i think the guy may have a set of snowflakes ill give him a buzz tomorrow and ask him if you would like Quote Selected
My score today Reply #8 – December 30, 2009, 08:45:38 PM i have a set of snow flakes and the radio bezal if u need it Quote Selected
My score today Reply #9 – December 31, 2009, 03:18:02 AM I'm local-ish to him, that's why I asked. Quote Selected
Topic: My score today (Read 1470 times)
previous topic - next topic
