I am finally getting around to stripping the car. It's an 86 302 with about 350k miles on it. Body is pretty rough and so is some of the interior. Car drove fine before a broken oil pan, but the front end is all worn out and the shocks and and struts are junk. If you need any electrical or sensors most if not all is there and worked. Both motor mounts are shot with broken brackets.
Let me know if it can be any use to anyone. Located in grantsville utah, 84029.
I think Jerry will want the O2 sensor harness.
Also, how's the charging system wiring up by the dash on the driver side? You know, the bundle with all the fusible links?
I'm looking for a radio/temperature control bezel.
I believe all the fuseable links are good. Old and dirty, but should be good. It was a lower option gs model, so it might not have every one, but I can pull it all out and take a pic in the next day or two. I did a 3g upgrade but I left the stock charging cable taped up. The connector was melted as were the wires up till they splice from two down to one wire.
It was the standard cable operated heater/a.c. panel. I believe it has the rear window defrost as well.
So is mine. I need the bezel/surround that runs from the dash cap down to the console. I've found several out of T-birds but they have a different pattern on them than the Cougars did :(
That's what always happens. Any time a fox chassis car goes up in flames, the problem is almost always that connector. I hard wired mine and took the connector out.
Dos this car have the full console or the consolette?
Is the driver side door window an unbroken non vent window? I just broke the one on my 86 tc and need one baaaaad!
How much for the following:
Tab/tad sensors and mounts.
Headlamp switch
Power door lock switches - both sides.
Sorry guys I've been busy at work. Haven't had a day off since I posted this. I have a few pm's and stuff. I'll get back to you in a few days when I can mess with stuff.
Just so you are aware, this GS will have the simulated wood "Woodtone" pattern on it, not the "Black / Gray grid" pattern that your XR-7 has.
Haystack, I'm interested the C pillar Cougar emblems if they are in decent shape.
Thanks!! I didn't catch that it was a GS :(
How are the door lock actuators?
How are the tail lights?
Tail lights are cracked. Would pass saftey, but not much life left in them.
No door actuators, I converted this over to almost a stripper model. There is no power anything. Blank console plate.
What kind of shape is the engine wiring harness?
Are either of the front fenders, or either of the doors in good shape?