Getting things ready for paint this spring. Parts need to fit 83-86 Bird.
[LIST=1]
- Hood
- Trunk lid
- Rear bumper cover
- Hood latch mechanizm and cable (Don't need the pull piece inside of car)
- Inner fender plastic
- Piller trim (up/down pieces on door/window)
That is all I can think of for now, if you're willing to share some of your parts stash that would be awesome. The big pieces will have to be local to Columbus, Ohio area.
Willing to trade this fiberglass hood for stock hood/latch cable. *Note* pics are way better than hood's current condition. I will take new pics of the chips that the hood has in it. Hood pins are manditory for this setup but hinges work fine in the back.
To bad your so far away!! I either have or can get my hands on pretty much everything but a trunk lid!!
Custompunk PM sent :evilgrin:
Dibs on the hood :mullet:
I take it that the hood doesn't have provisions for the factory latch hence the reason for the hood pins.
I'll check for a few things on the parts car I have.
I'll be working on the car here in a little while, I'll grab some more pics of the hood. 1BadBird, it does have a spot for a latch however, I'm not sure if that spot is in the right place / lines up with existing latch.
I wish you weren't in Ohio, I've wanted a Cowl for a while now..
You could try this place, it's this weekend and it looks like you don't have that far to drive.
http://springswap.com/swap_pdf/2013_ford_flyer.pdf
Ron
Thanks for the heads up. Usually if I know about it I attend. They hardly ever have any T-bird/Cougar stuff. It's rare to find foxbody stuff at all. Most stuff there is 60's 70's mustang.
Custompunk, sent you a PM :D