My 88 t-bird should have a 49" driveshaft but i'll have to confirm that. The local junkyard gets $11 for an aluminum driveshaft and they have many out of Aerostars that are 59" in length. I'm thinking about getting one and paying to have it cut and rebalanced. Anyone have experiences with doing this?
I have looked into that personally. Shouldnt be too expensive to have a shop cut and rebalance it for you... some may just machine it to xxx diminsion
The last time one of the guys in our local club needed an aluminum shaft, I called up one of my buddies who knew a shop that could do it...I think it ran him around $200...expect prices to vary.
Good luck,
Don