Print Page - Digital Dash Coolant Sender

Title: Digital Dash Coolant Sender
Post by: 88BlueBird on May 30, 2007, 10:41:53 AM

What is the correct Coolant Sender to use for the the Full Digital Dash? Does anyone have the part # this part?

Title: Digital Dash Coolant Sender
Post by: dudeman351 on May 30, 2007, 07:37:10 PM

F2AZ-12A648-A hope this helps

Title: Digital Dash Coolant Sender
Post by: 88BlueBird on May 31, 2007, 10:35:49 AM

My wiring harness only has the 1-wire connector. How would I install the 2-wire connector for my full digital cluster?

Title: Digital Dash Coolant Sender
Post by: dudeman351 on May 31, 2007, 07:00:38 PM

check on cool cats. there is a write up on it.

Title: Digital Dash Coolant Sender
Post by: raser13 on May 31, 2007, 10:53:17 PM

Quote from: 88BlueBird;150911

My wiring harness only has the 1-wire connector. How would I install the 2-wire connector for my full digital cluster?

you just ground the black wire and the other one goes where the old wire is.

Title: Digital Dash Coolant Sender
Post by: jcassity on June 01, 2007, 01:12:21 AM

humm,,leme see now,,,,,

wasnt it Tom (turbocoupe50) who a while back mentioned that ,,,,,,,,,,,,
SENDERS wire to the computer
SENSORS generally wire up to the dash

:flame:

terminology is about the same as the correct placement of a decimal point,, makes a big difference.
your sensor has a single wire,, while your sender has two.

Title: Digital Dash Coolant Sender
Post by: 88BlueBird on June 02, 2007, 12:22:16 PM

Thanks guys. I found a wiring diagram and it appears you are right. The other wire just goes to ground.

Fox T-Bird/Cougar Forums

Technical => Electrical Tech => Topic started by: 88BlueBird on May 30, 2007, 10:41:53 AM