Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - treflipboy

4
T-Bird/Cougar Parts & Cars FOR SALE / Original exterior trim still wrapped from Ford
I just sold my 88 tbird and now im stuck with a bunch of leftover stuff. This is all from Ford and still wrapped in the plastic. I did unwrap it so i can get pictures, but took pics before and after opening. Would love to see these get put to use instead of taking to the dump. Would also prefer selling all these pieces together. I do not have access to a computer very often, so i'd prefer an email or text. treflipboy@gmail(DOT)com or 915-525-224o

prices are undecided. Make me a reasonable offer, i know i paid a lot for these :/


In the pictures you can see some "sticky stuff" from the plastic wrap on a few pieces but it comes right off. only 1 piece has some pitting or marks on the chrome but it's perfectly smooth and nice.

Located in California, 93440
11
T-Bird/Cougar Parts & Cars FOR SALE / Misc. Parts for sale tbird
All prices NOT including shipping, [COLOR="red"]and as always open to offers![/COLOR] New carpeting for entire floor of 1988 tbird. PM for info
Located in California, 93440

Right tail light (paid $65 for this, so i hope it goes to a good home!) $$Offer

Side mirrors $8 each

XXX
12
Engine Tech / Map/Bap sensor location / help
ok, i think i've found my mistake. The port on the under side of the upper manifold is capped off still because i had it on mass air flow. Now that i changed the computer and left speed density on temporarily i need to run the vacuum line from the MAP to that port right?
13
Engine Tech / Map/Bap sensor location / help
It has it setup to run off mass air, but at the moment i have it on speed density. I undid the mass air connector from my computer and unplugged my sensor. Once i get everything squared away i'll go back to mass air. I know that my map doesn't have the little tad cover to make it so you can't attach a vacuum line, so I'm pretty sure it needs to go into the manifold, but i don't know where. I found the most logical port but it has a line going to the FPR. Online i can't find the answer. I know you're a Guru at this stuff vinnie :)
15
Engine Tech / Map/Bap sensor location / help
Or do i have my map/bap confused and is it the MAP sensor on the firewall? If so, where does the vacuum line from the MAP go into? Because all the slots on my manifold are filled.